Calibration for Lorca and Piura

Cydiance Lorca and Piura temperature data loggers are equipped with high accuracy and stable digital temperature/humidity sensors.

We confirm that all sensors used, are manufacturerd by Sensiron from the Switzerland. Sensiron processes the calibration on each unit which traces back to National Institute of Standards and Technology(NIST) from USA, Physikalisch-Technische Bundesanstalt (PTB) from Germany and National Physical Laboratory (NPL) from UK.

Each device is individually tested after its calibration.

You may find a calibration statement from Sensiron as attached from below link, which applies to all sensors supplied to Cydiance.

Calibration Certification Statement from Sensiron

Calibration for C0, C1 & B1

Cydiance C0,C1 and Cydiance B1 temperature data loggers are equipped with high accuracy and stable digital temperature sensors.

We confirm that all sensors used, are manufacturerd by Texus Instruments(TI) from the United States.TI processes the calibration on each unit which traces back to National Institute of Standards and Technology(NIST) from USA .

You may find a calibration statement from TI as attached from below link, which applies to all sensors supplied to Cydiance.

Calibration Certification Statement from TI

User Manual – B Series

User Manual - B Series

Bee-user-manual-guide.png

WARNING! DO NOT REMOVE the water-proof bag before or in use.

Config (optional!)

You may use the mobile App—Cydiance Hive to configure the logger before start the device. Download from the link below.
This step is however not a must, you may simply skip this step to use default setting. Configuration Instructions

Start

Press the button for 5 seconds till both LED light up, the LED will then flash every 3 seconds indicating the logger is working.

make a mark

Press the button once, the RUN LED will light up for 1 second, indicating a MARK has been made successfully. Total 8 MARKs can be made.

stop

The device can NOT be stopped unless
1/ plugged into computer with USB; or
2/ reach to maximum of data recording;

get the report

A, plug the usb into computer to get an encrypted PDF report;
B, use the Cydiance Hive App on phone to read report.

User Manual – C Series

User Manual - C0 & C1

WARNING!  Do not remove the plastic bag unless you have finished the trip or seen the Run(blue) LED solid.

Start

Press the button for 5 seconds till both LED light up, the LED will then flash every 3 seconds indicating the logger is working.

make a mark

Press the button once, the RUN LED will light up for 1 second, indicating a MARK has been made successfully. Total 8 MARKs can be made.

stop

The device will stop when,
1, being plugged into computer with USB; or
2, reaches to maximum data;
PS: Device manufactured before December 4th 2019 may be stopped manually by button.

get the report

Plug USB into computer. 1, if the device has stopped before plugging, a flash disk will pop up immediately with an encrypted PDF report; B, if the device is stopped by USB, you might have to wait a while till the RUN LED become solid, and then a flash disk will pop up with an encrypted PDF report;